A SERVICE OF

logo

6
USING ROUTING PROTOCOL
COMMANDS
This chapter describes how to use the following commands:
Routing Table Display Commands
display ip routing-table
display ip routing-table acl
display ip routing-table ip_address
display ip routing-table ip_address1 ip_address2
display ip routing-table ip-prefix
display ip routing-table protocol
display ip routing-table radix
display ip routing-table statistics
display ip routing-table verbose
Static Route Configuration Command
delete static-routes all
ip route-static
RIP Configuration Commands
checkzero
default cost
display rip
filter-policy export
filter-policy import
host-route
import-route
network
peer
preference
reset
rip
rip authentication-mode
rip input