Filter
Top Products
12 Dehumidifier
Operating Instructions
Water level
control switch
Automatic shut off
Disposing of collected water
The dehumidifier will turn off automatically when the bucket is full,
or when the bucket is removed or not replaced in the proper
position.
The bucket must be replaced in the proper position for the
dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the proper
position.
1. Empty the bucket manually.
2. Attach a length of garden hose to the threaded drain hose
connection to carry water to the drain.
When the bucket is full, pull out by
grasping the handle and empty it
into a large sink or tub and then
replace it properly.
Do not remove while
operating the dehumidifier.
It can cause water to drop on the
base pan or the floor.
Empty the bucket when the indicator
light turns on.
It is advisable to carry the
bucket by supporting it from the
bottom as well as by the handle.
Carrying by only the handle may
cause the handle or bucket cover to
break.
2. Remove the drain-hole cover.
(Fig2)
1. Connect a garden hose to the
threaded drain hose connector.
(Fig1)
NOTICE
NOTICE
4. Press the hose down and make
sure the “Arrow” is pointing upward.
(Fig4-1,4-2)
The hose attachment will
accept a standard garden hose
fitting.
Do not over tighten the hose when
connecting it to the hose connector,
use a rubber washer and tighten by
hand firmly without stripping the
plastic threads.
NOTICE
When being attached to hose connector drain hose connection, do not bend or kink the hose.
The hose should lie flat fom the dehumidifier to the drain.
DRAIN HOLE
COVER
HOSE
CONNECTOR
HOSE
CONNECTOR
3. Push hose connector tightly into
the drain-hole on Rear Grille.
(Fig3-1,3-2)
Fig1
Fig2
Fig3-2
Fig3-1
INSERT
TAKE OUT
Fig4-1
Fig4-2
5.The connection should be resemble
Fig5 when complete.
Fig5