Filter
Top Products
13
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Close the dishwasher door
4. Press the On/Off push button
The On/Off indicator light will come on.
5. Setting and starting the programme
Press the push button corresponding to the required
programme (see "Washing programmes" chart).
The indicator light corresponding to the programme
and the phase indicator lights foreseen for that
programme will illuminate.
If you want to select the half load option, press the
corresponding push button.
After about 3 seconds from the last pressure of a push
button the programme starts automatically.
Once the programme has started the phase indicator
lights will turn off except for the phase under way.
Note: it is possible to select a washing programme also
with the door slightly opened.
In this case the start of the programme will occur after
about 3 seconds from the closure of the door.
a) Press On/Off push button.
b) Select a washing programme.
c) Close the door.
The programme will start automatically after about 3
seconds from the closure of the door.
6. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it’s absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
To interrupt a washing programme in
progress
a) Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point in which it was interrupted.
b) Press the On/Off push button (in this case all the
indicator lights turn off). Press the On/Off push button
again; the programme will start from the point in
which it was interrupted.
To cancel a washing programme in
progress
To cancel a washing programme you have to reset the
dishwasher; press simultaneously the function push
buttons 2 and 3 until all the indicator lights will
turn off (except for the On/Off indicator light and
eventually the rinse aid and salt indicator lights)
indicating that the running programme has been
cancelled.
7. End of the washing programme
The dishwasher will automatically stop and the end of
programme phase indicator light (END) will illuminate.
The indicator light of the programme just ended will
remain on.
If the door is not immediately opened at the end of the
programme, air will circulate inside the dishwasher to
prevent residual steam recondensing on the dishes as
water droplets.
This device operates intermittently for about 20 minutes,
as long as the dishwasher is switched on.
if the On/Off push button is pressed or the door is
opened during these 20 minutes, the device will be
automatically cancelled.
Switch off the dishwasher by pressing the On/Off push
button, the On/Off indicator light turns off.
Open the door and wait a few minutes before removing
the dishes; in this way they will be cooler and the drying
will be improved.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Starting a washing programme