Yeoman 250 Stove User Manual


 
INSTALLATION INSTRUCTIONS
12
2. COMMISSIONING
2.1 Before lighting the Elegance stove, check the following
items: -
a) Fit of internal parts (firegrate, firebricks, baffles, and
fuel retainer).
b
) Door alignment, seals and catch operation.
c
) Operation of air controls.
2.2 If there are any problems with the fit or operation of any
of these items, this should be corrected before
continuing with the commissioning of the Elegance
s
tove.
2.3 Carry out a final smoke draw test, by first warming the
f
lue with a blowlamp, or similar, for about 10 minutes.
Then place a smoke pellet on the centre of the grate,
with the air controls open, and close the door. Smoke
should now be drawn up the flue and be seen to exit
from the flue terminal. This test should be completed
with all doors and windows in the room where the stove
is fitted closed. Should this test fail, the suitability of the
flue system and ventilation should be re-checked.
2.4 Light the appliance and gently allow the temperature to
increase slowly to operating levels. Check that no
combustion products are entering the room. When the
stove has reached a steady operating condition open the
main firedoor and carry out a spillage test with a smoke
match or pellet around the door opening.
2.5 If excessive spillage does occur, allow the appliance to
cool and re-check the suitability of the flue system and
ventilation.
2.6 Explain the safe operation of the stove and the use of
the controls to the user, along with the need to only use
suitable fuels. Also explain the cleaning and routine
maintenance requirements.
2.7 Explain the requirements to use a suitable fireguard
when children, elderly or infirm persons may be near the
appliance.
2.8 Record dealer/supplier details and installer details in
user instructions.
2.9 Record serial number in user instructions.
This
number will be required when ordering spare parts and
making warranty claims.
2.10 Give the copy of the user instructions to the
customer
.