Filter
Top Products
INSTALLATION PROCEDURE
En 5
English
Make sure to leave adequate ventilation space around the unit and follow the instructions below. The illustrations used in
each step are the examples of YSP-800 and YSP-900.
In order to secure the unit to the wall, you will need to attach the bracket to the wall first in a manner befitting the
structure and quality of the wall.
Choose a location where the wall can bear the weight of the whole unit.
Before installing the bracket, make sure of the size (see “DIMENSIONS” on the first page of this manual).
Choose a secure wall or beam to fasten the screws. Do not install them into walls made of weak
material that can easily come off, such as mortar or plywood wall panels. Loose screws could cause
the projector to fall, resulting in personal injury.
If the metal apparatuses are attached to the rear panel of your Digital Sound Projector, detach them from the rear left and
right sides. If the metal apparatuses are not attached to the rear panel of your Digital Sound Projector, proceed to step 3.
INSTALLATION PROCEDURE
1 Attach the large wall mount bracket to the wall.
Washer
(commercially
available)
4 mm Tapping Screw (commercially available)
In order to secure the unit to the wall, drive six (or more) tapping
screws from the outside through the holes in the wall mount bracket.
Installing into a dry
wall
Installing directly
into a wall, etc.
25 mm or more
25 mm or more
Beam, etc.
Dry wall
Installation example
Note
2 Detach the metal apparatuses from the Digital Sound
Projector. (Some models of YSP-800 only)
Metal
apparatus
Metal
apparatus
01_EN_SPM-K30.fm Page 5 Monday, June 18, 2007 5:59 PM