Filter
Top Products
10 Service
MAN0116 (Rev. 4/15/2004)
Service
Cont’d
Replace Vacuum Spindle Bearings
1. Remove vacuum housing from deck.
2. Remove bearing mount (41) from Deck. Leave
plastic coupler sleeve (43) attached to right deck
spindle.
3. Remove spindle assembly (20) from bearing
mount.
4. Remove cap screw (19) and cup washer (18)
from top of spindle.
5. Remove sheave (16) from spindle shaft (14). A
puller maybe required to remove sheave.
6. Press spindle shaft (14) through bearings (51)
and out of spindle housing (15).
7. Press bearings (51) from spindle housing.
Install New Bearings
1. Press new bearings (51) in spindle housing.
Make sure spacer (10) is installed between
bearings.
2. Reverse steps 1 - 6 and reassemble spindle
housing. Make sure all hardware is installed
correctly. See page -- for complete parts list.
3. Install bearing mount to deck. See ‘Install Bearing
Mount” on page 7.
4. Attach vacuum housing to deck and secure.
Figure 11. Vacuum Drive Spindle Assembly
41
43
14
10
51
15 20
51
19
18
16
39
CD004