Filter
Top Products
WARNING
OF
POTENTIAL
INJURY
This product contains moving parts.
To reduce the risk of injury; unplug the
machine before servicing.
Maintenance and repairs must be done
by qualified personnel ONLY.
CAUTION:
Using non-Windsor parts to repair this
machine will void the 6-3-1 warranty.
Warranty information is located on the
back of this manual.
Suggested Service Parts List
DESCRIPTION
PART NUMBER
Belt
11031
Brush Bearing
09019
115V
Cord Assembly (USA/Japan) 23572
230V Cord Assembly (Europe)
23178
Dome Assembly
28034
Dome Gasket
35060
Hose Cuff. Short Blue
27508
Hose Cuff. Longer Blue
27354
Hose Cuff, White
27079
Jet Assembly
44055
Jet
44061
Jet Seal
44051
Jet Body w/Seal
44052
Manifold Assembly
(No
Jets)
54094
Pump Service Kit
47176
Screen/Filter, Dome
34140
Screen/Filter, Solution Tank
73250
Solution Release Cable
27665
Solution Release Lever
51200
115V
Switch
72074
230V Switch
72121
Valve
84134
Dailv Maintenance:
These procedures are followed at the end of
each work period to extend the life of the ma-
chine.
1.)
2.)
3.)
4.)
5.)
6.)
7.)
Empty unused cleaning solution by
disconnecting clear hose on back of
machine and pouring into floor drain.
Inspect and clean solution filter screen
inside tank and vac intake screen
inside dome.
Flush the system. Fill solution tank
with 1 or 2 gallons (4
-
8 liters) of clean
hot water. With machine over floor
drain turn on vac/pump switch until
solution tank is empty.
Inspect spray pattern of jets.
Remove jets and rinse if clogged.
After each use, rinse recovery tank with
fresh water. Periodically inspect the
recovery tank and decontaminate if
necessary, using a Hospital Grade
Virucide or a l-l 0 bleach to water
solution. Waste water should be disposed
of properly.
Remove any lint or debris from brush.
Inspect power cord. Remember, this
cord will lay on a damp surface.
Warning:
IMMEDIATELY REPLACE WORN OR
FRAYED POWER CORDS.
8.)
Inspect hoses. Worn or cracked
hoses may cause loss of vac pressure.
9.) Place the brush in the storage
position. Press back slightly on the
main handle, and place the brush
adjustment lever in the “STORE”position.
For infrequent use or long periods of stor-
age,
flush the system with a neutralizing solution
of 1 quart (1 liter) white vinegar mixed with 2 gal-
lons (8 liters) hot water. Flush the system with
clean hot water after neutralizing.
8
98353