Filter
Top Products
CONTROLS
CUTTER 24V 86039070 04/10/07
3-7
7. BRUSH PRESSURE LEVER
Adjusts the amount of brush pressure to the floor by
raising or lowering the scrub deck.
To apply brush pressure, lower brush pressure lever to
floating position.
To apply additional pressure, place lever in restricted
position. Lock the lever into the lower notch. Push the
lever forward to move in a downward motion. Pull back
on lever and release for floating position.
To decrease brush pressure, raise lever to up position.
8. SOLUTION CONTROL KNOB
Controls solution flow to scrub deck.
To increase flow, rotate knob clockwise.
To decrease flow, rotate knob counterclockwise.
If the brush motors are turned off or the propel control
levers are in neutral, the flow is automatically interrupted
until the motors are turned on again. This feature
prevents unintentional draining of the solution tank and
allows the operator to adjust the solution flow to the
scrub deck without resetting each time the scrubbing
operation is interrupted.
9. VACUUM SWITCH
Controls the vacuum motor.
To start vacuum motor, press the bottom of the switch.
To stop vacuum motor, press the top of the switch.
10. SQUEEGEE LIFT LEVER
Raises and lowers the squeegee.
To lower the squeegee, lift the lever from its raised
position.
To raise the squeegee, lift the lever from its lowered
position.
11. SQUEEGEE PITCH ADJUSTMENT
KNOB
Adjusts the deflection at the ends of the
squeegee.
To increase squeegee blade deflection
at the ends, turn knob counterclockwise.
To decrease squeegee blade deflection
at the ends, turn knob clockwise.
12. SQUEEGEE DEFLECTION
ADJUSTMENT KNOBS
Adjusts the deflection along the entire
length of the squeegee.
To increase squeegee blade deflection
along the entire length, turn the two
knobs at the squeegee ends counter-
clockwise.
To decrease squeegee blade deflection
along the entire length, turn the two
knobs at the squeegee ends clockwise.