Filter
Top Products
SCRUB DECK/BRUSH
MOTOR
1.
Remove
(4)
screws holding motor
shroud.
7.
Squeegee tracking can be controlled
by adjustin tension of squeegee
springs.
NOT%
:
Position
recovery
hose
as shown before making adjustments.
2.
Remove batteries and squeegee as
-
sembly. Lay machine on side.
3.
Remove center screw holding drive
plate. Slide drive plate off motor shaft.
WHEELS/CASTERS
1.
Use allen wrench to remove wheel
retaining screw.
4.
Disconnect motor leads from terminal
block.
5.
Remove
(4)
screws holding brush motor
to scrub deck.
Brush
Motor
6.
Remove
(2)
motor thru
-
bolts and lift off
end bell. Replace brushes when worn
to
310
inch.
2.
Use arbor press to replace bearings as
required. Use grease gun to lubricate
bearings through zerk fitting on wheel
hub and caster axle.
Limited
Warranty:
Windsor Industries warrants that the
terms:
Windsor machine covered
by
this warranty is free from
defects in workmanship and
materiqls under the following
SOLUTION STRAINER
1.
An inline solution strainer is located
under chassis behind left wheel. Re
-
move sediment bowl and screen period
-
ically and rinse clean with hot water.
6
YEARS
On Rotationally Molded Polyethylene Tanks.
3
YEARS
On Traverse Drive Motors, Gear Units, AC Induction Polisher Motors, all Metal
Chassis and Metal Frames.
1
YEAR:
On all other parts which are not specifically referenced herein, plus an extra
year
(2
years total) on Rectified DC Polisher Motors and Scrubber Brush Motors.
The warranty period shall commence at the date of FIRST PURCHASE BY THE END USER
FROM AN AUTHORIZED
WINDSOR DISTRIBUTOR and applies to defective parts only, not
to failure caused by abuse or normal wear.
Windsor will, at its option, repair or replace without charge, except for normal transportation
costs, parts that fail under normal use and service when operated and maintained in accord
-
ance with the Owners Instruction Manual and the Preventive
Maintenance Guide where
applicable. This warranty shall apply to defects in material and workmanship only and
does not apply to:
a) transportation damages, b) alterations by unauthorized persons,
c) misuse or abuse (including use of incompatible or corrosive chemicals or overloading of
capacity), d) failure caused by lack of proper maintenance and cleaning,
e) batteries and
chargers which are warranted by the original manufacturer for one year, and
f) normal
wear on items such as belts, brushes, bearings, capacitors, carbon brushes, clutches,
cords, filters, finishes, gaskets, hoses, pulleys, relays, rectifiers, and switches.
The warranty is in lieu of all warranties, expressed or Implied, and releases Windsor from all
other obligations and liabilities. It is applicable only in the U.S.A., Canada, Australia, and
New
Zealand. Windsor Industries is not responsible for costs of repairs performed by
persons other than those specifically authorized by Windsor. This warranty does not apply
to damage or
loss
of income due to malfunctloning of the machine. USE
OF
PARTS NOT
APPROVED BY
WINDSOR
WILL
VOID WARRANTY.
If
a difficulty develops with this machine, contact either the Dealer from whom you
purchased the product or write to:
6