Filter
Top Products
CLEANING PROCEDURE
86038280 04/04/07
3-8EN
G
Release intermittent trigger switches or
turn off continuous setting on solution
switch approximately 1 foot before ending
cleaning pass.
Push down on handle to raise vacuum
shoe and brush before moving to the next
cleaning pass. Overlap brush contact
area a minimum of 1inch on the right
(close cleaning) side of machine. Overlap
a minimum of 2inches on the left (drive
belt) side of machine. Refer to illustration
for the left and right side of the machine.
STEP
1
STEP
2
STEP
3
Start at wall closest to power outlet. For
small areas, pull straight back without
pushing down on handle.
1in.
(25mm)
OFF
1ft.
(30cm)
1. This machine can be operated in either
direction. For smaller areas operate the
machine by pulling rearward.
2. For larger unobstructed areas, flip the handle
and use the machine’s brush assisted
propelling motion.
1
2