Filter
Top Products
OPERATIONS
STEP
1
Remove electrical cord and literature from
recovery tank. Fill solution tank (see filling
operations, page3-5).
Plug cord into grounded outlet.
STEP
2
Note: Be sure dome is seated on recovery
tank, and float shut-off is installed correctly.
STEP
3
Adjust brush to proper setting.
Note: For good operation the brush must
skim the carpet. If circuit breaker trips raise
brush to prevent damage to motor or carpet.
Turn on both Vacuum and Pump motor
switches (“ON”=“I”).
STEP
4
CORRECT
INCORRECT
1/8in
(3mm)
PUMP VACUUM
ON ON
CADET 86038220 03/16/07
3-6