Filter
Top Products
CLEANING PROCEDURE
Start at wall closest to power outlet. Pull
straight back without pushing down on
handle.
STEP
1
Release intermittent trigger switches or
turn off continuous setting on solution
switch approximately 1 foot before ending
cleaning pass.
Push down on handle to raise vacuum
shoe and brush before moving to the next
cleaning pass. Overlap brush contact
area approximately 1inch.
STEP
2
During operation, observe the following: The
Admiral is equipped with clear internal covers to
facilitate operator viewing of dirty solution and
vacuum air flow.
During operation, observe the vacuum intake
cover. Large amounts of water or foam entering
the vacuum system can damage the vacuum
motor. If you notice either condition, shut down
the machine immediately. Empty recovery
tank and/or add defoamer to recovery tank.
STEP
3
STEP
4
SOLUTION
INTAKE COVER
VACUUM
INTAKE COVER
1in.
(25mm
)
OFF
1ft.
(30cm)
ADMIRAL 86038230 03/16/07
3-8