Whynter ARC-10WB Air Conditioner User Manual


 
18 | P a g e
CARE AND MAINTENANCE
IMPORTANT:
Switch off the air conditioner and disconnect the plug
from the power outlet
Drain water by removing the drain plug.
Always transport the air conditioner in an upright
position only.
CLEANING THE AIR FILTERS
To ensure the air intake is filtered properly and to
assure that your air conditioner runs efficiently, it is
recommended to clean the air filters at least once
every two weeks.
This unit has two air filters; the upper and the lower
filters.
Switch off the air conditioner and pull out the upper
air filter from the unit (Fig 26).
Remove the lower filter by loosening the screw and
taking down the air inlet grille. (Fig.27 & 28).
Use a vacuum cleaner or tap lightly to remove loose
dust and dirt from the filters. Then rinse them
thoroughly under warm or cold running water (no
hotter than 100F.)
Dry thoroughly before re-inserting the filters.
WARNING! Never operate the air conditioner without the
filter in place.
CLEANING THE AIR CONDITIONER
Always switch off the air conditioner and disconnect
the plug from the power supply outlet before cleaning
the air conditioner.
Use a soft damp cloth to wipe the body of the unit.
Never use harsh chemicals, oil-based products,
detergents, chemically treated cloths or other
cleaning solutions. These could possibly damage the
body of the air conditioner.
END OF SEASON STORAGE
Switch off the air conditioner and disconnect the
power plug from the power supply outlet before
cleaning the air conditioner.
Clean the air filters.
Drain the condensed water COMPLETELY.
On a warm day, turn on the Fan only mode for half a
day so that the inside can dry out completely.
Wrapped the power cord and bundle it with the tape
(Fig.29).
Remove the batteries from the remote controller.
Disconnect the exhaust hose and cover the window /
wall hole with the adaptor cap. (Fig.30)
It is recommended that the air conditioner be put
back into its original carton for storage.