Filter
Top Products
15
A cooling anticipation setting of less
than 10 may cause decreased compres-
sor life.
To adjust anticipation, press
SET
CLOCK
and
SET
DAY
at the same time. The display will show
HEAT 8 (this is the factory preprogrammed
heating anticipation setting). You may se-
lect any anticipation setting from 4 to 40.
Whenever adjusting anticipation, increase
or decrease the displayed number by only
one or two digits, then let the system run for
a while to see if the adjustment is sufficient.
If the heat cycles are too short, press
TIME
FWD
to increase the cycle time. If the heat cycles
are too long, press
TIME
BACK
to decrease the
cycle time. To set cooling anticipation, press
SET
CLOCK
and
SET
DAY
at the same time again. The
display will show COOL 14 (factory
preprogrammed cooling anticipation). Use
the
TIME
FWD
and
TIME
BACK
buttons to adjust antici-
pation. Press
RUN
PRGM
to return to your pro-
gram.
• LOW BATTERY INDICATOR — The word
BAT will flash on the display if the 9 volt
alkaline battery is low and should be re-
placed.
• AUDIO PROMPTING — Each time you
press a button, the thermostat will beep (this
feature works only when the thermostat is
attached to the wall and 24 VAC power is
present to the thermostat).
CAUTION
!