Filter
Top Products
19
Error Codes
All Takagi units are self diagnostic for errors. If
there is a problem with the installation or the unit, it
will give a signal, through a flashing light on the
circuit plate, to communicate the source of the
problem. If the unit has a TK-RE01 remote control
installed, this will give also give a numerical error
code. Consult the following chart for the meaning
of an error code:
TK-RE01
Computer Board
TK-RE01 Check Point
03 Wrong Gas
70 Computer Board
Blinking One Time
71 Solenoid Gas Valve
31 Output Thermistor
Blinking Two Times
32 Input Thermistor
11 Hi-limit, Igniter
12 Flame Sensor, Hi-limit
55 Main Gas Valve
51 Proportional Gas Valve
Blinking Three Times
72 Abnormal Burning
61 Fan
Blinking Four Times
21 Pressure switch
74 Remote Controller
For technical support contact Takagi toll free at (888) 882-5244, or check
our website at www.takagi-usa.com.