Filter
Top Products
9
Complete Installation
NOTE: Handle air conditioner with care.
1. Make sure the free end of the ground wire is outside of the
cabinet.
2. Insert air conditioner into cabinet.
3. Connect green ground wire to cabinet base with ground
screw. Position ground wire pointing straight up. Put excess
ground wire between coil and air conditioner cabinet.
4. Install foam seal in the gap between air conditioner base and
cabinet. Push foam seal in at the sides and trim any excess
material.
5. Remove the 2 front panel screws from air conditioner base.
6. Insert front tabs of front panel into top of cabinet and swing
front into place.
7. Attach bottom front of panel with front panel screws. Replace
control knobs (on some models).
NOTE: Route power supply cord through notch in front panel.
8. Plug into a grounded 3 prong outlet.
A. Green ground wire
B. Ground screw
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
WARNING
Failure to do so can result in back or other injury.
WARNING
Electrical Shock Hazard
Failure to do so can result in death or
electrical shock.
Connect green ground wire to ground screw.
A
B
+
+
+
A. Foam seal
A. Front panel screws
B. Power supply cord notch
A
A
B
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Do not use an extension cord.
Do not use an adapter.
Do not remove ground prong.