Filter
Top Products
8
Mode
1. Press and hold MODE.
2. Choose AUTO, COOL, FAN or POWER SAVER.
■ Auto - Automatically controls fan speed while cooling
room. The fan speed cannot be changed, but the
temperature can be adjusted by pressing the up or down
arrow button.
■ Cool - Cools room. Press FAN SPEED to choose fan
speed. Then adjust the temperature by pressing the up or
down arrow buttons.
■ Fan - Operates the fan at Turbo speed, without cooling.
The display shows “FO” (fan only).
■ Power Saver - Fan and compressor run only when
cooling is needed. Turns fan off when room temperature
reaches the temperature setting on the thermostat.
Fan Speed
NOTE: The Fan Speed button will operate only when the Cool or
Power Saver mode has been selected.
1. Press and hold FAN SPEED until you see the indicator light
for the desired setting.
2. Choose TURBO, HIGH or LOW.
Temperature
■ Press, or press and hold, the up arrow button to raise the
temperature 1ºF (0.56ºC) until it reaches 86ºF (30ºC).
■ Press, or press and hold, the down arrow button to lower the
temperature 1ºF (0.56ºC) until it reaches 64ºF (18ºC).
Timer Delay
To set the Timer for a 1- to 24-hour delay until the air
conditioner turns on (the air conditioner must be Off):
1. Press TIMER. Indicator light will flash.
2. Press the up or down arrow button to change the delay time
from 1 to 24 hours.
3. Press TIMER or wait 10 seconds. Indicator light will remain
on.
To set the Timer delay for a 1- to 24-hour delay until the air
conditioner turns off (air conditioner must be On):
1. Press TIMER. Indicator light will flash.
2. Press the up or down arrow button to change the delay time
from 1 to 24 hours.
3. Press TIMER or wait 10 seconds. Indicator light will remain
on.
To keep the previous settings
1. Turn off air conditioner.
2. Press TIMER. Indicator light will flash.
3. Press the up or down arrow button to change delay time from
1 to 24 hours.
4. Press TIMER or wait 10 seconds.
To change the previous settings
1. Turn on air conditioner.
2. Adjust MODE to desired setting.
3. Adjust FAN SPEED to TURBO, HIGH or LOW.
4. Adjust temperature between 64ºF (18ºC) and 86ºF (30ºC).
5. Turn off air conditioner.
6. Press TIMER. Indicator light will flash.
7. Press the up or down arrow button to change delay time from
1 to 24 hours.
8. Press TIMER or wait 10 seconds.
To clear Timer delay program
NOTE: Air conditioner can be either on or off.
Press and hold TIMER for 3 seconds. Indicator light will turn off.
To see the time remaining (in hours)
1. Press TIMER once after it has been set.
2. While the display is showing the remaining time, you can
press the up or down arrow button to increase or decrease
the time.