Whirlpool AD50USS Dehumidifier User Manual


 
2-7
3. Pour water through opening into a sink or
tub.
4. Reinstall bucket.
IMPORTANT: If the Empty/Adjust Bucket
light comes on, the dehumidifier will not
operate. Empty or adjust bucket.
Option 2—Connect Drain Hose
If you plan to run your dehumidifier continu-
ously, you may want to attach a garden hose
to the drain hose connector.
1. Use a flat-blade screwdriver to gently pry
out the drain hose connector cover. Discard
the cover.
2. Remove bucket.
A.Drain hose connector cover
B.Bucke
t
B
A
3. Attach a garden hose to drain hose connec-
tor on the inside of the dehumidifier. Hand
tighten.
4. Place the other end of garden hose into a
floor drain. Check to see that the hose lies
flat and is in the drain.
5. Reinstall bucket.
A.Garden hose
B.Drain hose connecto
r
B
A
NOTES:
To use the bucket without the garden hose,
remove the garden hose. Then reinstall
bucket.
The bucket must be installed and properly
aligned for the dehumidifier to operate with
or without a garden hose connected.
NORMAL SOUNDS
When your dehumidifier is operating normally,
you may hear sounds such as:
Compressor sounds, which may be loud.
This is normal.
Clicking sounds when the dehumidifier or
compressor turns off and on, and when the
Automatic Shutoff Switch is working.
Air movement from the fan.