Filter
Top Products
A single-phase, 60-Hz, AC-only,
electrical supply is required on a
separate circuit. A 15amp time-
delay fuse or circuit breaker is
required Copper wire (#14
gauge) is required. The fuse size
must not exceed the circuit rating
specified on the model and serial
label. The model and serial label is
located behind the front panel on
the base flange.
Specific electrical requirements
are listed in the chart. Follow the
requirements for the type of plug
on the power supply cord.
W&g
requirements
Plug Type A
Plug Type B
;$f%g
P
Lb
W” blade
receotacls
0
‘J
3-pron
fJou”cf”g-
ype wall
receptacle.
grouncllng
prow
power supply cord
groundlng prong
115volt -
230/208-volt -
103% min.,
197.6~ min.,
126.5~ max.
253~
max.
7.5-amp
12-amp rating
rating or less or less - use a
- a double single outlet
outlet is and a sep-
acceptable.
orate circuit.
7.6- through
12- through 16-
12-amp ratings
amp ratings -
- use only a
use only a
jingle outlet
single outlet
and separate and a sep-
Zircuit. orate circuit.
Exordmended grounding
For your personal safety, this
appliance must be grounded.
This appliance is equipped with a
power supply cord having a
3-prong grounding plug. To
minimize possible shock hazard,
the cord must be plugged into a
mating, 3-prong grounding-type
wall receptacle, grounded in
accordance with the National
Electrical Code, ANSVNFPA 70 -
latest edition*, and all local codes
and ordinances. If a mating wall
receptacle is not available, it is the
personal responsibility and
obligation of the customer to have
a properly grounded, 3-prong wall
receptacle installed by a qualified
electrician.
Now start...
With air conditioner in room where
it will be installed.
I
THROUGH-THE-WALL
INSTALLATION INSTRUCTIONS.
It is the customer’s responsibility
and obligation to have this
product installed by a qualified
technician familiar with through-
the-wall room air conditioner
installations.
appropriate header
if required \
Pl
ss
Frame
Construction
appropriate header
if required,
lintel
I
alternate
construction
for plaster
-
’
Brick Veneer
to frame.
Construction
1
When using a wood,
n
metal or plastic molding,
the finish frame should line up with
inside wall. If the plastered wall is
to be flush with the cabinet and
no molding is used, the finish
frame must be set l/2 inch into
the wall.
hi
wall opening
w
t
24-718”
2,
-I
Dimension
Cut opening
depends on wall
through the wall.
thickness and
Remove insulation.
type of molding.
3
Use 1 -inch or heavier
lumber for wood frame.
n
Measure depth of wall
opening and frame. Apply wood
preservative to the outside
exposed surface.
4
Insert the frame in the wall
opening. Square and level
n
frame. Nail frame securely
to the wall studs.
5
Remove air conditioner and
n
front panel from carton.
6
If you plan to install a drain
hose to the back of the air
1 condiiioner, install the drain
hose connector as follows:
1, Remove the drain hose
connector, gasket and screws
from the plastic bag.
2. Attach them on the back of the
air conditioner as shown above.
Note: If you are installing a new
unit into an existing sleeve, you
may need to modify the sleeve for
the drain connector.
Page 3