Filter
Top Products
4
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These
fixtures meet all UL specifications.
1. Turn off power at circuit box to avoid possible electric shock.
2. Thread mounting screws (A) into universal mounting plate or cross bar (B) approximately
1/4 inch (see fig. 1).
NOTE: If universal mounting plate or cross bar (B) was preinstalled, remove cap nuts (C) and universal
mounting plate or cross bar (B) from back plate (D), leaving mounting screws (A) in place.
3. Secure universal mounting plate or cross bar (B) to outlet box (E) with outlet box screws (F)
(not included).
4. Identify color coding of fixture wires (see fig. 2).
5. To connect wires, take black fixture wire (group A from fig. 2) and place evenly against
black outlet box wire. Do not twist wires.
6. Fit wire connector (G from fig. 1) over wires and twist until there is a firm connection. If
wire connector (G) easily comes off, reattach and check again for a firm connection.
7. Repeat steps 5 and 6 with the white (group B from fig. 2) fixture wires and outlet box wires.
8. Partially thread green grounding screw (H) into side hole (I) on universal mounting plate or
cross bar (B) (see fig.1).
9. Wrap ground wire from fixture around green grounding screw (H), leaving enough excess
wire to then connect ground wire and outlet box wire with wire connector (G), if applicable.
10. Tighten green grounding screw (H). Do not over tighten.
11. Tuck wires inside outlet box (E) (see fig. 1).
MOUNTING AND WIRING INSTRUCTIONS
FIXTURE ASSEMBLY INSTRUCTIONS
Warning: This fixture is for indoor use only.
1. Position back plate (D) over mounting screws (A) and secure with cap nuts (C).
2. Install glass shade(s) (J) into socket(s) (K) and secure with clip(s) (L).
3. Install lamp(s). Do not exceed recommended wattage.
4. Turn power back on at circuit box.
12 pg_W-214_EFS 9/8/05 10:35 PM Page 4