Wayne-Dalton 9000 Door User Manual


  Open as PDF
of 4
 
Wayne-Dalton, a Division of
Overhead Door Corporation
P.O. Box 67, Mt. Hope, OH 44660
www.Wayne-Dalton.com
Part No: 307899
REV7 01/25/2013
Release disk
Spring
©Copyright 2013, Wayne-Dalton, a Division Of Overhead Door Corporation
TOOLS REQUIRED:
(1) Electric Drill
(1) 1/8” Drill Bit
(1) 3/4” Dia. Hole Saw
(1) 1-1/4” Dia. Hole Saw
(1) 7/16” 6 Point Nut Driver
(1) 7/16” Wrench Or Socket
(1) Pliers/Wire Cutter
(1) Phillips Screw Driver
(1) Standard Screw Driver
(1) Center Punch
IMPORTANT NOTICE! REFER TO THE DOOR MODEL INSTALLATION INSTRUCTIONS MANUAL FOR
IMPORTANT SAFETY NOTICES.
Rim Cylinder/Night Double Lockbar Lock
Installation Instructions and Owner’s Manual
All Residential Door Models: 5000, 9700, 9800,
8000 & 9000 Series & Wood Doors
Parts Breakdown
NOTE: The illustrations shown on this page are general representations of
the door parts. Each specific door models may have unique variations.
(2) #12 Pan head screws*
Outside
handle
Inside door
handle
(2) 1/4” - 20 x 1-3/4”
Self tapping screws
Retainer
nut
1/4” - 20 x 11/16”
Self drilling screws
(2 per guide) Or 1/4” - 14
x 1” Lag screws (Wood
doors only)
Washer
3/8” x 1”
(2)
Keys*
Rim cylinder*
Trim ring*
(4) #8 x 1/2” Pan
head screws*
Night latch
assembly*
Phillips head machine screws
(2) 1” (9100/5120/9800)
(2) 1-1/4” (8700/9400/
9600/5140/8300/Wood)
(2) 1-1/2” (9700)
(2) 1-3/4” (8000/8100/8200/8500)
Lock backup plate
(8300/8500/8700/9700/9800/Wood)
Universal lock stile
(9100/9400/9600/5120/5140)
(2) Foam tape
(9100/9400/9600/5120/5140)
3/4” x 2-1/2”
1/4” - 20
Nylon locking
nuts
1/4” - 20
Carriage
bolts
(2 or 4) Lock
bar guides
next