Wayne-Dalton 9000 Door User Manual


  Open as PDF
of 4
 
Step 4: Installing the Secure Lock
8000/9000 Series & Wood doors (Fig.1-3), locate the
inside handle and uncoil the lock cable, then thread the
cable through the inside handle as illustrated (see Fig.1).
Locate the secure lock striker plates over the pre-punched
holes in the vertical track nearest the center of the lock
section (see Fig.2). Fasten the striker plates to the vertical
track using (2) 1/4-20 x 9/16” track bolts and flanged hex
nuts. Lock bars are embossed “R” for right side and “L”
for left side. Place the lock bars into the slots in the secure
lock base (see Fig. 3). Attach the springs to the tabs on the
base and the lock bar. Position the end of the right lock
bar into the slot in the right striker plate. Move the base of
the secure lock back 1/8” from the edge of the section.
Attach the secure lock to the section with (4) 1/4-20 x
11/16” self drilling screws. Repeat for the left side. Feed
one end of the lock cable through the slotted hole of a
lock bar and secure with (1) 1/4-20 x 9/16” track bolt.
Pull the cable taut, but not enough to pull the lock bar out
of the striker plate. While holding taut, feed the lock cable through the slotted hole of the remaining lock bar,
secure with (1) 1/4-20 x 9/16” track bolt and flanged hex nut.
NOTE: Ensure that the bolt is through the front of the lock bar and the nut is on the back of the lock bar
with cable going through the front of the lock bar.
Operate the lock several times to make sure the lock bars clear the striker plates when the handle is turned and the
lock bars engage the striker plates when the handle is released. Adjust the cables if necessary. Trim off the excess
cable with wire cutters after the lock is operating satisfactorily.
4
1
2
3
4
Fig. 1
Fig. 2
Fig. 3
HOOK SPRING OVER
TABS ON LOCK BAR
AND BASE
SLIDE LOCK BAR
THROUGH THE
FRONT SLOT
LOCK BARS ARE
EMBOSSED FOR
IDENTIFICATION
ALIGN LOCK BAR
INTO FRONT SLOT
INSIDE
HANDLE
1/4-20 X 9/16”
TRACK BOLTS
1/4-20 X 11/16”
SELF DRILL SCREWS
1/4-20 FLANGED
HEX NUT
1/8” OFFSET FROM
EDGE OF DOOR
LEFT HAND
LOCK BAR
RIGHT HAND
LOCK BAR
LOCK CABLE
VERTICAL
TRACK
STRIKER
PLATE
SECURE LOCK
BASE II
9900 SERIES DOORS
USE BACK SLOT
 previous