Filter
Top Products
900 SERIES ROLLING SERVICE DOORS
900 SERIES
ROLLING SERVICE DOORS
1
As the originator of the interlocking
slat rolling door, Wayne-Dalton
offers a variety of standard slat
sizes and designs in galvanized
steel, aluminum and stainless
steel. Each is designed to meet
certain requirements and all have
the following characteristics:
• Reversible, water-shedding
design. Provides a natural
water-shed.
• Free-acting joints. Are
interlocking, yet permit easy
articulation when the door coils.
• Superior quality materials. To
meet or exceed all design
criteria.
• Durability. Extended operation
due to fewer moving parts by
design.
• Strength. All doors designed to
meet minimum 20 PSF
windload, using alternate
endlocks or windlocks as
standard.
• Space Saving. Compactness of
design at coil enclosure for
maximum overhead clearance
and free traffic access through
and around doors.
• Colors Available.
White, blue, gray, tan,
brown.
GREAT FEATURES THAT
MAKE A BETTER BUY:
Galvanized, pre-painted curtain
of minimum 24 gauge steel has
interlocking slats with endlocks/
windlocks riveted to ends of
alternate slats. Designed to
withstand 20 PSF windload. Note:
Curtains are pre-painted to
eliminate “white rust.”
Windlocks are rugged stamped
galvanized steel or malleable iron.
Pre-punched top slat holes cut
field labor installation costs. See
below for
curtain options.
Extra-strong double-angle
galvanized bottom bar with
astragal is formed of two
1
¼
8
"
minimum thick steel angles and a
half-slat. It reinforces lower edge of
curtain against wind pressure, and
permits varied lock, astragal and
safety edge options. Hangs freely
on curtain to reduce friction.
Preassembled for ease
of installation.
Roll-formed hot dipped
galvanized steel guides are
fabricated from precisely formed
angles and channels with integral
windlock bars. They precisely
guide curtain travel, and can
withstand windloads to 20 PSF.
Groove mountings are provided at
top of guides to assure smooth
transition of the curtain into the
guides.
3
2
1
900 Series
No. 2—Curved-faced single crown slat is
available in up to 20 gauge steel or to 18
B&S gauge aluminum. Depth of crown:
1
¼
2
", 1
3
¼
4
" on centers.
No. 17—Flat-faced slat. Offered in up to 20
gauge steel or to 16 B&S gauge aluminum.
Depth of crown:
1
¼
2
", 1
5
¼
8
" on centers.
For easier door specifications or product questions call the WayneTec Consulting Service 1-800-764-1457.