Filter
Top Products
15
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed:
INSTALLATION
11
Stacking Sections
Power Drill
7/16” Socket Driver
Lock
section
NOTE: For door section identification see page 5.
NOTE: Make sure hinges are flipped down, when
stacking another section on top.
With assistance, lift second section and guide rollers
into the vertical tracks. Keeping the ends of the
sections aligned, install remaining section(s), except
top section, in same manner.
Starting with the center most hinge, flip up the hinge
leaf, and hold it tight against section. Secure it to the
section using (2) 1/4”- 14 x 7/8” self drilling screws.
Repeat for all remaining center hinges.
For single end hinges: flip end hinge leaf upward
and fasten the hinge to the above section with (4)
1/4”-14 x 7/8” self tapping screws. Repeat for the
right hand end hinge(s).
For double end hinges: flip up both end hinge leafs
and secure the hinges to the above section with (6)
1/4”-14 x 7/8” self tapping screws. Repeat for the
right hand end hinge(s).
Repeat for other sections except the top section.
NOTE: Install lock at this time (sold separately). See
side lock instructions on page 25.
Center hinge
(2) 1/4” - 14 x 7/8”
Self drilling screws
Hinge
leaf
Section
Single end hinge
Hinge
leaf
(4) 1/4” - 14 x 7/8”
Self drilling screws
Section
Double end hinge
(6) 1/4” - 14 x 7/8”
Self drilling screws
Hinge leafs
Section