Filter
Top Products
3
Operating Instructions And Parts Manual
1. Tether Float Switch Kit 60022-001 60022-001
2. Top Cover Kit 60030-001 60030-001
3. Impeller Plate 15958 15958
4. Impeller 60000-001 60000-001
5. Volute 60016-001 60007-001
Part Numbers for Models
Ref. CDT33 SPT33, SPT50
No. Description CDT50 SSPT33, SSPT50
For Replacement Parts, call 1-800-237-0987
Please provide following information:
-Model number
-Serial number (if any)
-Part description and number as shown in parts list
Address parts correspondence to:
Wayne Water Systems
101 Production Drive
Harrison, OH 45030
Specifications
Power supply requirements......120V, 60 hz
Motor .........................................Single phase, oil filled
Horsepower................................1/3 HP (CDT33, SPT33, SSPT33)
....................................................1/2 HP (CDT50, SPT50, SSPT50)
Liquid temperature range ........40°F to 120°F
Circuit requirements..................15 amps (min)
Dimensions.................................11
1
/
2
” high x 9
3
/
4
” base
Cut-in level (factory set)............13”
Cut-out level (factory set) .........7”
Construction
Motor housing.................Cold rolled steel
Volute...............................Cast iron (CDT33, CDT50)
..........................................Glass Reinforced Thermoplastic
(SPT33, SPT50, SSPT33, SSPT50)
Impeller ............................Glass reinforced thermoplastic
Shaft .................................Low carbon steel
Seals..................................Buna N
Discharge..........................1
1
/
2
” NPT
Motor Cover.....................Glass reinforced thermoplastic
Replacement Parts List
• Only use factory parts to repair
this pump.
www.waynewatersystems.com