Filter
Top Products
English
14
Cleanup - Latex materials (continued)
5. Unclip the return tube from the suction tube and place it
into the waste container. Turn the PRIME/SPRAY knob
to PRIME.
7. Place the original material container next to the waste
container. Aim the spray gun into the side of the
original material container and hold the trigger.
9. When cleaning solution ows from the spray gun, keep
holding the trigger and aim the spray gun into the side of
the waste container.
10. Trigger the gun until the uid owing out of the gun is
clear. You may need to empty the waste container and
continue ushing.
11. Turn the PRIME/SPRAY knob to PRIME and trigger gun
to relieve pressure.
Move on to Cleaning the Spray Gun Components.
6. Turn water supply on. Turn pump ON (l). Water will go
into the suction tube and out through the return tube.
Let pump run for a few minutes to allow the return tube
to be ushed.
8. While pulling the trigger, turn the PRIME/SPRAY knob
to SPRAY to purge material from the hose back into the
original container.
SPRAY
PRIME
Waste
container
Containers should
be touching
Original
material
container
Hold trigger
Hold trigger
Spray material
into original container
Spray water into
waste container
Leave pump running
through steps 7 and 8.
Keep holding trigger through next steps.
SPRAY
PRIME