Filter
Top Products
USING THE CORDLESS HAND VACUUM CLEANER
1. Remove the vacuum cleaner from the
charging base.
2. To use the hand vacuum cleaner slide the
on/off button forward.
3. To turn the unit off, slide the on/off button
backwards.
4. A crevice tool is provided for cleaning narrow, hard to reach places. A dusting brush
is provided for cleaning upholstery and furniture.
CAUTION: The suction hole must be open and free of any obstruction at all
times. Otherwise, the motor will overheat and could become damaged.
INSTALLATION OF WALL MOUNT
Hold the wall mount on to a spot you wish to install the wall mount and draw drill points
through the wall mount holes. Please make sure to be close enough to the next
power outlet to connect the cord. Drill 2 holes at the marked points. Prior to drilling
verify that no water, gas or power lines are close to the holes to be drilled. Install the
wall mount with the supplied screws and wall anchor. Please check if the wall anchor and
screws match your wall type (wood, concrete, and drywall). You might need to use
different screws and wall anchors that fit your application better
. (see FIG 4)
FIG. 4
CHARGING THE HAND VACCUM CLEANER
NOTE: Ensure that the On/Off switch is in the “Off” position before charging.
A. Connect the cable to the charging station with the power source at the vacuum
cleaner. Now connect the power cord to a 120 volt power outlet.
OR
B. Connect the cable to the wall mounted charging station as
displayed in FIG. 4. Now connect the power cord to a 120 Volt
power outlet. (see FIG. 5)
FIG. 5
7