Filter
Top Products
CLEANING
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND
FOLLOW LOCKOUT / TAGOUT PROCEDURES.
Daily
Exterior
Clean the exterior finish of the broiler with a mild soap solution or similar grease-dissolving
material. DO NOT use Dawn Dish Detergent.
Broiler
Clean the broiler and doors, especially if fruit pies or tomato sauce were baked or meats
roasted, or if there have been any spillovers.
Stainless Steel
Routine cleaning of stainless steel may be done with ordinary soap or detergent and water. DO
NOT use Dawn Dish Detergent. To prevent water spots and streaks, rinse the broiler thoroughly
with warm water and wipe dry with a soft, clean cloth. The addition of a rinsing agent will also help
prevent spotting.
When scraping off heavy deposits of grease or oil from stainless steel broilers, use stainless
steel, wood, plastic or rubber tools. Never use ordinary steel scrapers, knives or plain steel
wool.
Fingerprints may be minimized by applying a cleaner that will leave a thin, oily or waxy film. Wipe
the cleaner on and remove the excess with a soft, dry cloth. Subsequent fingerprints will usually
disappear when wiped lightly with a soft, dry cloth containing a little of the cleaner. If the surface is
especially dirty to start with, wash first with soap or detergent and water.
Soaking with hot, soapy water will help greatly to remove burned- on foods and grease. Stubborn
deposits can be removed with scouring powder mixed into a paste and applied with stainless steel
wool or sponges. Do not use ordinary steel wool because particles that remain can eventually rust
and cause unsightly spots and stains. Rub in the direction of the polish lines.
Straw -colored or slightly darkened areas may appear on stainless steel appliances where
temperatures reach 500°F (260°C) or more. This "heat tint" is caused by a slight oxidation of the
stainless steel and is not harmful.
To control or minimize this condition, never use more heat than is absolutely necessary. Do not
use oversize pots where whipping of the flames will occur.
Heat tint can be removed by scouring vigorously with stainless steel wool and a paste made of
scouring powder. Rub in the direction of the polish lines.
– 14 –