Vulcan-Hart BVD36FP32(F,L)N-1 Indoor Fireplace User Manual


 
Page 319400-3-0406
Before enclosing the vent pipe assembly, operate the appliance to ensure it is venting properly.
If this appliance is installed directly on carpeting,
tile or other combustible material other than wood
flooring the appliance shall be installed on a metal or
wood panel extending the full width and depth of the
appliance.
The base referred to above does not mean the fireproof
base as used on wood stoves. The protection is for rugs
that are extremely thick and light colored tile.
• Children and adults should be alerted to the hazards
of high surface temperatures and should stay away
to avoid burns or clothing ignition.
Young children should be carefully supervised when
they are in the same room as the appliance.
Clothing or other flammable material should not be
placed on or near the appliance.
Adequate accessibility clearances for servicing and
proper operation.
This appliance must not share or be connected to a
flue serving a separate solid-fuel burning appliance.
Keep the area around your appliance clear of
combustible materials, gasoline and other flammable
vapor and liquids.
Under no circumstances should any solid fuels
(wood, coal, paper or cardboard etc.) be used in this
appliance.
The flow of combustion and ventilation air must not
be obstructed in any way.
Due to high temperatures the appliance should be
located out of traffic and away from furniture and
draperies.
Any part removed for servicing the appliance must
be replaced prior to operating the appliance. Work
should be done by a qualified service person.
Keep burner and control compartment clean.
Vent cap is hot while fireplace is in operation.
Installation and repair should be done by a
QUALIFIED SERVICE PERSON. The appliance
should be inspected before use and at least annually
by a qualified service person. More frequent
cleaning may be required due to excessive lint from
carpeting, bedding materials, etc. It is imperative
that control compartments, burners and circulating
air passageways of the appliance be kept clean.
DO NOT put anything around the fireplace that
will obstruct the flow of ventilation air.
Clearance in accordance with local installation
codes and the requirements of the gas supplier.
DO keep the appliance area clear and free from
combustible material, gasoline and other flammable
vapors and liquids.
DO examine venting system periodically and
replace damaged parts.
DO make a periodic visual check of pilot and
burners. Clean and replace damaged parts.
DO NOT use this fireplace if any part has been
under water. Immediately call a qualified service
technician to inspect the heater and to replace
any part of the control system and any gas control
which has been under water.
Any safety screen or guard removed for servicing
an appliance must be replaced prior to operating
the appliance.
IMPORTANT SAFETY INFORMATION