Filter
Top Products
Page 1519400-3-0406
WARNING: Failure to position the parts in accordance with
this diagram or failure to use only parts specifically approved
with this appliance may result in property damage or personal
injury.
Attention: Do not use Figure 19 or Figure 20 to order logs. Refer
to parts view on page 30 and parts list on page 31 to order logs
and/or ember material for your appropriate fireplace model.
Before you begin: If you are installing logs into the BVP42
model then this fireplace is supplied with a set of three ceramic
fiber logs. Do not handle these logs with your bare hands. Always
wear gloves to prevent skin irritation from ceramic fibers. After
handling logs, wash your hands gently with soap and water to
remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of
this fireplace. Sooting and other problems may result if the logs
are not properly and firmly positioned in the fireplace. Please
refer to Figure 18, Figure 19, and Figure 20 and corresponding
WARNING, when completing the following log placement
steps.
1. Place bottom log onto main burner. Align holes on bottom
log with (4) locator pins on burner.
2. Place rear log on rear log shelf. Place rear log so that the
locator holes align with the (2) locator tabs in the log support
shelf.
3. Place top branch onto flat area of rear log and over the front
of the bottom log.
4. Place decorative rock in front of grates and sides of main
burner.
ATTENTION: Do not place decorative rock on logs or on
burner. The decorative rock should only be placed on the
fireplace floor.
5. After all logs are properly positioned, place small "dime"
size pieces of Rockwool lightly across the front round "blue
flame" ports. Place the ember material (Rockwool pieces)
side by side. Do not stack more than one layer of embers
across the burner ports. See Figure 18.
TOP BRANCH
REAR LOG
BOTTOM
LOG
Figure 19
Figure 18
EMBER PLACEMENT
REAR LOG LOCATOR TABS
BOTTOM LOG LOCATOR PINS
Figure 20
LOG PLACEMENT (3 LOG SET)