Filter
Top Products
English
English
76
HOW TO USE
Using your Vornado Heater is easy. Just follow these simple steps.
Position your heater so the vortex beam of warm air is directed
across the room unobstructed. Position it in a location that
is representative of the room temperature. Avoid areas of
temperature extremes such as cold drafts and heat registers.
Please refer to IMPORTANT INSTRUCTIONS at the beginning
of this owner’s guide.
Plug into a standard grounded wall outlet.
Press the POWER button.
ONE-KNOB OPERATION
This innovative user interface is sophisticated yet simple. Press
the knob to “wake-up” or turn on the screen on the base unit,
rotate the One-Knob control unit until the desired mode you
want to adjust is displayed. Press the button to accept this mode,
then, rotate the knob left or right to select desired setting. The
unit is then set, or you may press the One-Knob again to adjust
another mode, and continue to adjust additional settings in the
same manor.
REMOTE CONTROL
Fully control the Heater remotely with the Remote, no more
getting up to adjust the temperature. You can turn the unit ON
and OFF, switch the mode from FAN ONLY, to LOW HEAT or HIGH
HEAT, adjust the desired set temperature up or down, and set the
automatic-off timer. As you adjust the remote, the base unit will
“beep” to indicate that it has received your signal.
CARE & MAINTENANCE
Your heater has no user serviceable parts. Do not disassemble the
unit – it will void your warranty. If service is required, return your
heater to Vornado (see Warranty section).
The motor is permanently lubricated and requires no oiling.
Because your heater moves a substantial amount of air, it will
require regular cleaning. Be sure to unplug the unit prior to any
cleaning activity.
Use a vacuum cleaner with the brush attachment to clean any
accumulated dust on the front grill and the side air inlets. During
the off-season or extended periods of non-use, store your heater.
Unplug the unit and bundle the cord. Save the plastic bag the
heater was shipped in so you can cover the unit and minimize
settling dust.
1.
2.
3.
4.
5.
iCONTROL OPERATING CONTROLS
1
2
3
4
6
5
7
POWER ON/OFF
Front light illuminates when power is on.
MODE
HIGH HEAT 1500 watts, LOW HEAT 750 watts, or FAN ONLY.
TEMPERATURE
Allows you to select your desired comfort level. Use the UP arrow
to raise the set temperature. Use the DOWN arrow to lower the set
temperature.
TIMER
The timer can be set in hour intervals up to 9 hours. Press the TIMER
button to go into timer mode. In timer mode, use the UP arrow to
add hours. In timer mode, use the DOWN arrow to remove hours.
REMOTE
The remote control functions the same as the unit
controls. The remote requires 2 AAA batteries. To
replace the batteries remove the cover located on the
bottom side of the remote.
SOUND
When a setting is changed you will hear a “beep”
from the unit.
LCD DISPLAY
Dims for no-glow night operation.