Vornado Vornado Electric Heater User Manual


 
English
5
This heater is equipped with a thermal safety shut-off system,
designed to turn off the heater when an internal overheating
condition is detected (see How To Use “RESETTING YOUR
VORNADO HEATER,” to determine how to check and
reset the heater).
This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to defeat this safety feature.
Do not operate this product with any electronic speed-control
device on the same circuit.
Do not use heater to dry human or animal hair/fur or articles
of clothing.
SAVE THESE
INSTRUCTIONS
HOW TO USE
Using your Vornado Heater is easy. Just follow these simple steps.
Position your heater so the vortex beam of warm air is directed
across the room unobstructed. Position it in a location that is
representative of the room temperature. The unique side-angled
air inlets allow the heater to be placed closer to walls than
possible with most ordinary heaters (but do not place close to
combustibles). Avoid areas of temperature extremes such as cold
drafts and heat registers. Please refer to IMPORTANT
INSTRUCTIONS at the beginning of this owner’s guide.
Plug the power cord into a standard wall outlet.
Set the POWER switch to ON.
Set THERMOSTAT to the highest setting. When the room reaches
the desired comfort level, turn the THERMOSTAT knob slowly
counterclockwise until the heat cycles off (easier to detect when
FAN is set to AUTO).
CARE & MAINTENANCE
Your heater has no user serviceable parts. Do not disassemble the
unit – it will void your warranty. If service is required, return your
heater to Vornado (see Warranty section).
The motor is permanently lubricated and requires no oiling.
Because your heater moves a substantial amount of air, it will require
regular cleaning. Be sure to unplug the unit prior to any cleaning
activity. Use a vacuum cleaner with the brush attachment to clean any
accumulated dust on the front grill and the side air inlets.
During the off-season or extended periods of non-use, store your
heater. Unplug the unit and bundle the cord. Save the plastic bag
the heater was shipped in so you can cover the unit and minimize
settling dust.
1.
2.
3.
4.