Filter
Top Products
English
13
Troubleshooting
Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker /
ground fault interrupter, or replace fuse. For assistance, contact a licensed electrician.
The unit has blown a fuse. Cease usage and unplug. Contact Consumer Service for assistance.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
This is normal. Water is being dispensed into Base.
Water level in Tank is empty or too low. Refill with clean, cool tap water. (See FILLING WATER TANK for
instructions.)
Unit has reached its set point. When set humidity level is reached, the unit will not produce mist until humidity
level in the room drops below humidity set point.
Airflow is blocked. Remove obstruction.
Unit settings are too low. Set to High Output and Continuous Humidity for maximum humidity output.
Mineral Cartridge is no longer removing minerals from water. Cartridge needs to be replaced (See MINERAL
CARTRIDGE REPLACEMENT for instructions.)
Unit and Transducer is in need of cleaning. (See CLEANING AND MAINTENANCE for instructions.)
Water is too hard. Use distilled water.
Unit fails to power on.
Unit makes a bubbling or
gurgling sound.
Unit is not producing de-
sired amount of humidity
or mist output has ceased.
White dust has accumu-
lated on Mist Outlet or on
flooring below.
Problem Possible Cause and Solution