Vornado VH2 Electric Heater User Manual


 
English6
RESETTING YOUR VORNADO HEATER
Your Vornado Heater has a multi-level safety shut-off system designed
to prevent overheating. Overheating may occur when the inlets or
outlet are blocked, a foreign object prevents the blade from turning,
or the appliance tips over. If this happens, the safety shut-off system
will cut power to the heat element and you will need to manually reset
the heater.
Set the POWER switch to OFF and unplug the unit.
Remove any obstructions.
Wait 5–10 minutes, allowing the unit to cool down.
Plug in the unit and place in desired position.
Set the POWER switch to ON. Your Vornado Heater should now
function normally.
If the safety shut-off system repeatedly shuts off your heater or if it
will not reset after following the above procedure, DO NOT
ATTEMPT TO DISASSEMBLE THE UNIT. Call Vornado Consumer
Services Department toll-free at 1-800-234-0604.
1.
2.
3.
4.
5.
VH2 OPERATING CONTROLS
POWER ON/OFF
Illuminated when the unit is ON.
THERMOSTAT
Allows you to select your desired
comfort level.
FAN
In the AUTO position, the fan will
cycle on and off with the heating
element. In the CONT. position,
the fan will run continuously.
HEAT
LOW HEAT 750 watts
HIGH HEAT 1500 watts
1
2
3
4
1
2
3
4
VH102 OPERATING CONTROLS
POWER ON/OFF
Illuminated when the unit is ON.
THERMOSTAT
Allows you to select your desired
comfort level.
For fan only use - select the FAN
setting and press CONT. on the
FAN switch.
1
2
3
4
1
2
3
4
FAN
In the AUTO position, the fan will cycle on and off with the heating
element. In the CONT. position, the fan will run continuously.
HEAT
(I) LOW HEAT 750 watts
(II) MEDIUM HEAT 1125 watts
(III) HIGH HEAT 1500 watts