Filter
Top Products
English
5
Always plug heaters directly into a wall outlet/receptacle. Never
use with an extension cord or relocatable power tap (outlet/power
strip).
Operate this heater only in its upright position. Do not operate
this heater on an elevated surface such as a shelf or desktop. Use
only while placed on the floor.
This heater is equipped with a thermal safety shut-off system,
designed to turn off the heater when an internal overheating
condition is detected (see How To Use “RESETTING YOUR
VORNADO HEATER,” to determine how to check and
reset the heater).
This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to defeat this safety feature.
Do not operate this product with any electronic speed-control
device on the same circuit.
Do not use heater to dry human or animal hair/fur or articles
of clothing.
SAVE THESE INSTRUCTIONS
HOW TO USE
Using your Vornado
®
VH101 is easy. Just follow these simple steps:
Position your VH101 so the vortex beam of warm air is directed
across the room unobstructed. Position it in a location that is
representative of the room temperature. The unique side-angled
air inlets allow the heater to be placed closer to walls than possible
with most ordinary heaters (but do not place close to
combustibles). Avoid areas of temperature extremes such as
cold drafts and heat registers. Please refer to IMPORTANT
INSTRUCTIONS at the beginning of this owner’s guide.
Plug the power cord into a standard wall outlet.
Set the POWER switch to ON. The amber light will be on anytime
the POWER is on.
Set the mode switch to HIGH or LOW HEAT, or select the center
position on the switch for FAN ONLY.
Any servicing should be performed by an authorized
service representative.
Save the retail carton and cord twist-tie to use when storing the
heater in the summer and spring seasons. Secure the cord by
using the provided twist tie, or if you no longer have the twist-
tie, simply wrap the cord with a rubber band. Place the heater
back into the retail carton and close top flaps to avoid dust
accumulation on and in the heater.
1.
2.
3.
4.
5.
6.