Vornado CR1-0116-06 Fan User Manual


 
9
English
Grill Removal
Models 533, 633, 753 • Remove the 3 screws located in between the ribs
of the inlet grill at roughly 10, 2, and 6 o’clock positions. Screw locations are
indicated by an arrow on the side of air inlet (B). Do Not remove the 2 screws
on the pivot arms. Place the circulator facing you. Position your hands at the
10 and 2 o’clock positions, lift up and back on the outer grill to release the grill
clips (C). If necessary repeat the process against the remaining two clips at
the 5 and 7 o'clock positions. Replace by lining up the clips with the holes and
firmly snapping the grill back into place. Replace all the screws.
²
²
²
²
²
²
²
B
C
WARNING: To avoid risk of fire, electrical shock, or injury to persons, unplug
the Air Circulator before removing the grill.
Models 510, 530, 610, 630, 723, 733, 743, 783, 735, 745, 795 • Remove
the screw (only necessary on model 530). Depress one of the grill clips (A) by
placing your thumb against the outside surface of the clip and pressing down-
ward towards the motor, applying slight pressure forward. A flathead screw-
driver can also be used if the clips are difficult to release. Usually by releasing
one clip, the grill can be removed. If the grill cannot be removed, repeat the
process on remaining clips. Replace by lining up the clips with the holes and
firmly snapping the grill back into place. Replace the screw (model 530 only).
²
A
Screw
(530 only)