Filter
Top Products
11
English
Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact
Vornado Air LLC at 1-800-234-0604.
1. Use the integrated handle for lifting and
carrying. Located on the back of heater.
2. Position the heater so airflow is not
obstructed.
3. Unwrap power cord from bottom of
heater. Plug power cord into a standard
grounded wall outlet.
COOL DOWN
When you power off your heater, it
automatically enters a cool down
routine in which the heating element
turns off and the fan exhausts
remaining heat. During Cool Down,
the display counts down from eight,
then powers off completely.
4. Press the power button ( ) and select a Mode
( ). Next, set thermostat to desired temperature
using (-/+). SET will illuminate and the numbers
will flash on the LED display. After five seconds
of selecting set temperature, ROOM will display.
You may also select Fan Only by pressing ( ).
Default settings upon first use will be High Heat
and set temperature of 75 degrees.
MODEL AVH30 ONLY
Set timer to automatically power the unit off
by pressing the ( ). The number 0 will appear
on the display. Press ( ) to select the amount
of time in one-hour intervals, up to 12 hours.
To cancel the timer operation, select 0 hours.
The timer will set after five seconds of making a
selection.
After the timer is in operation, press the ( ) and
the remaining amount of time before the unit
powers off will flash on the display. If you press
the ( ) a second time while viewing countdown
hours, the timer will cancel.
HOW TO USE
If the heater is in sleep mode, touch
the controls once to wake and again
to adjust settings.
Wrap excess cord inside the Cord
Storage. Use the notches, located inside
the Cord Storage, to secure the power
cord in place or adjust length during use.