Filter
Top Products
ENGLISH USER MANUAL
3. Empty by tilting the container (1) backwards and pour the liquids into a floor
drain or similar.
4. Wipe float valve (2), filter (3) and the motor top with a damp cloth before the
motor top is reinstalled to the container.
5. Replace the float valve assembly and power head. Secure with the latches.
Emptying GV702-EU
1. Drain hose: This mode has a draining hose (1) that easy and comfortable
drain the container from liquids, Detach the drain hose (1) from the bracket
(2) by pulling hose backwards from the cleaner. Place the drain hose end
near a floor drain and then remove the plug at hose end. The natural
pressure will then drain the liquids from the container.
2. Emptying from the container: Pull the lower parts of the latches outwards
and release the motor top. Remove the motor top.
3. The suction hose can be attached during emptying from the container (3).
Grasp with on hand at the handle at the lower part of the container. To
avoid movement of the trolley-place, one foot at the base part (4) of the
trolley. Then tilt the container backwards and pour the liquids into a floor
drain or similar.
4. Wipe float valve (5), filter (6) and the motor top with a damp cloth before the
motor top is reinstalled to the container.
5. Replace the motor top. Secure with the latches.
MAINTENANCE
To keep the machine performing well for many years, Please follow the following maintenance procedures.
﹡
﹡﹡
﹡Always confirm that the machine is unplugged prior to performing any maintenance or repairs.
1] Make sure that the cable is not cut or damaged. (If it is, contact the nearest authorized service center for
replacement)
2] Thoroughly clean the tank, do not let it sit for a long time with dust or dirty water.
3] The cloth dust bag can be washed and must be completely dry before use.
3] Lubricate casters with a water resistant lubricant every month.
4] Check machine for loose or missing nuts and bolts and replace as necessary.
5] Check the filter, and clean it after each use.
6] The motor is built for maintenance-free operation and does not need any particular service. The carbon brushes
may need to be replaced due to normal wear and tear caused by using the vacuum cleaner over time, and they
can be replaced only by an authorized VIPER distributor.
ATTENTION
1. To avoid the risk of electrical shock, always insure the four insulation bush (1) are
installed.
10 GV25-EU GV35-EU GV702-EU GV12066(1)2009-01
1
1
2
4
3
2
3
5
6
1