Filter
Top Products
ENGLISH USER MANUAL
2) Step on red head release lever to
lower the head to operating
position.
3) Turn power switch to “on”
position.
4) While operating machine,
periodically check the lights
located on the head of the
machine.
a. Green Light = Machine is
functioning properly
b. Yellow Light = Bag is full
(machine will
automatically shut down
after :35 seconds once
bag is full)
c. Red Light = Check brush
assembly
5) If the Yellow Light is illuminated,
it is time to replace the filter bag
with a new one, or the pickup
hose has an obstruction.
6) If the Red Light is illuminated,
UNPLUG THE MACHINE and
check the brush for obstructions.
VACUUMING WITH ACCESSORY
TOOLS AND WAND
!!! While using the wand and
accessories, the brush inside the
head assembly is spinning.
!!! Though the brush is spinning,
it is elevated off the floor, so it
will not damage the carpet.
1) Plug power cord into a grounded
outlet.
!!! Do not use an extension cord
in conjunction with the standard
power cord.
2) While keeping the machine in
storage position, remove the
wand from its storage position in
the back of the housing.
3) Attach the desired attachment to
the end of the wand.
4) Turn power switch to “on”
position.
5) While operating machine,
periodically check the lights
located on the head of the
machine.
a. Green Light = Machine is
functioning properly
b. Yellow Light = Bag is full
(machine will
automatically shut down
after :35 seconds once
bag is full)
c. Red Light = Check brush
assembly
6) If the Yellow Light is illuminated,
it is time to replace the filter bag
with a new one, or the pickup
hose has an obstruction.
7) If the Red Light is illuminated,
UNPLUG THE MACHINE and
check the brush for obstructions.
MAINTENANCE
To keep the machine performing
well for many years, please follow
the following maintenance
procedures.
!!! Always confirm that the
machine is unplugged prior to
performing any maintenance or
repairs.
1) Check filter bag prior to use to
confirm that it is not full or
damaged. For optimal
performance, the bag should be
replaced when ¾ full, or if the
bag is damaged.
2) Check exhaust filter to ensure it
is clean and properly installed.
3) Check brush assembly to ensure
that the brush bristles are not
worn out, or clogged with debris.
4) Clean outside of machine with a
mild cleaner and cloth.
5) If the supply cord is damaged, it
must be replaced by the
manufacturer, its service agent
or similarly qualified persons in
order to avoid a hazard.
10 GTR1500-EU VA50531(1)2009-12