Filter
Top Products
3
ASSEMBLY INSTRUCTIONS
Before assembling, please review all instructions.
1. Carefully open box to avoid damaging the lamp when using a sharp
knife.
2. Remove lamp (fully assembled) and set on table.
3. Using a Philips head screwdriver (included), carefully unscrew
the three screws holding the Optix
®
Glare Control Filter in place.
Remove fi lter and save for later.
4. Carefully insert the GU-24 Natural Spectrum
®
light bulb (included)
into lamp by fi rmly holding bulb base and pushing down and rotating
slightly in a clockwise direction to seat properly. Note: Make sure
bulb is fully inserted into the socket. The bottom of the bulb base
should touch the plastic housing of the lamp.
5. Place Optix
®
fi lter on lip of of inner shade cup, align holes and
tighten fi rst Philips head screw. DO NOT OVERTIGHTEN. Continue
to insert and tighten the two remaining screws.
6. Plug lamp into an appropriate outlet and turn on the switch.
7. Adjust height for optimum illumination.
8. Do not use with an extension cord or on a circuit with a dimmer
switch.
9. Save the packaging in case you need to send the lamp to Verilux for
servicing.