Filter
Top Products
7
HEADERAssembly Instructions
Read Instructions Carefully Before
Assembly:
1. Connect the two ends of the Power
Cord (between the Base and the
Shaft) using the lock connectors.
2. Carefully tuck excess Power
Cord into the Shaft. DO NOT
CUT OR SHORTEN THE POWER
CORD.
3. Insert the Gooseneck and the
Shaft into the Base.
4. Check direction of the lamp and
the hole on the Base, then use
a Phillips Head Screwdriver (not
included) to tighten the screw into
the hole.
CAUTION: BE VERY CAREFUL
NOT TO PINCH ANY PART OF
THE CORD BETWEEN ANY
METAL PIECES.
MISE EN GARDE : PRENDRE
SOIN DE NE PAS PINCER LE
CORDON DANS DES PIÈCES
MÉTALLIQUES.
Fig. 1