www.vax.co.uk
4
assembly
3. How to Assemble
Handle Assembly: Tool required: Phillips screwdriver
Detach dirt container from back panel of cleaner by
pressing dirt container release button and tilting forward.
Slide handle through top of back panel. Insert carry handle
through holes in back panel (see Fig.3/2).
Insert one (1) screw through front of cleaner to secure handle.
Secure carry handle with two (2) 1” screws through front of
cleaner (see Fig.3/3).
Re-attach dirt container by aligning bottom of dirt container
to bottom of cleaner and push forward to snap into place.
Secure Back Hose:
Wrap hose around back of hose caddy. Push hose wand
down into the right side of cleaner and push the handle
flat against the cleaner (Fig.3/5).
Tool Storage:
Attach tools: (a) Slide the dust brush onto post on the
lower tool caddy with the bristles facing out. (b) Clip Turbo
Tool into the caddy on the front of the handle. (c) Slide the
extension tube / crevice tool into the round slot on the left
side of the cleaner (Fig.3/6).
Fig.3/1
Fig.3/4
Fig.3/5
FRONTBACK
a
b
SIDE
c
Fig.3/6
Fig.3/2
Fig.3/3
Vax V-008T User Guide.qxd 28/6/07 13:57 Page 4