Filter
Top Products
4. Clip TurboTool™ on to the front of the TurboTool™
caddy (Fig.3/4).
5. Wrap the lower hose around the back of the hose
caddy (Fig.3/5A). Push hose tube down into the
right side of cleaner (Fig.3/5B).
6. Slide the dusting brush on to the post on the
upper tool caddy with bristles facing out (Fig.3/6A).
Slide the extension tube/crevice tool into the round
slot on the front right side of tool caddy (Fig.3/6B).
3. How to Assemble
IMPORTANT: Always remove the power plug from
the electrical outlet before assembling or before
removing accessories.
Tool required: Phillips screwdriver.
1. Guide the power cord into the opening. Slide the
upper handle into the TurboTool™ caddy (Fig.3/1).
2. Insert the handle fastener into the back of the
TurboTool™ caddy (Fig.3/2).
3. Insert one (1) screw into the front and tighten
until secure (Fig.3/3).
How to Operate
4
How to Assemble
5
Fig.3/2
a
FRONT
BACK
b
Fig.3/3
4. How to Operate
Cord Release
Turn the quick release for easy cord removal (Fig.4/1).
Clip cord into cord guide to keep out of the way
while vacuuming.
Adjustment for Different Floor Types
Turn the brushbar height adjuster according to the
surface being cleaned (Fig.4/2).
NOTE: For easiest adjustment, place cleaner in full
upright position.
AB
CAUTION: The brushbar continues to rotate
while the hose is removed or in use, and at all
times while the vacuum cleaner is on. Keep hair,
loose clothing, fingers and all parts of the body
away from the brush area while the vacuum
cleaner is on. The cleaner must be in the
upright position to lift the rotating brushbar off
the carpet when cleaning above the floor.
Vax recommend that the carpet height adjuster
is turned to its highest position when using the
tools.
NOTE: Model V-008SP only is NOT suitable for
hard floor cleaning.
On/off Pedal
Plug the cord into the electrical outlet. Turn the
vacuum cleaner on by depressing the foot switch
located on the back left side of the vacuum cleaner
(Fig.4/3). The vacuum cleaner can be turned off by
pressing the on/off switch again.
Handle Release Pedal
To release the handle, push the handle release pedal
located on the lower left side of the cleaner (Fig.4/4).
Carpet Cleaning
Move the handle and adjust it to the desired position
for (A) storing the upright or (B) operating the cleaner.
De-press the handle release pedal again (C) to clean
under furniture (Fig.4/5).
Fig.3/1
Fig.3/5
Fig.3/6
Fig.3/4
Fig.4/1
Fig.4/3
Fig.4/5
Fig.4/4
Fig.4/2
a
b
c
A
B
A
B
C
Vax V-008S 6th.qxd 4/6/05 11:29 AM Page 4