Filter
Top Products
13
104309
OWNER’S MANUAL
INSTALLATION
Continued
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place one-piece log set on grate to fit
as illustrated in Figure 17. Make sure
middle section at bottom of log set is
seated into “U”-shaped cutout in cen-
ter of chassis (see Figure 17).
Note:
36”
model has more features but fits on the
chassis the same. Log will fit securely
on chassis.
IMPORTANT:
Make sure
log does not cover any burner ports.
2. Place lava rock around base of heater.
Figure 17 - Installing Golden Oak One-Piece Log Set
Figure 18 - Installing Golden Oak One-Piece Log set (Top View)
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
One Piece Log Set
Burner
Middle
Section at
Bottom of Log
Set
"U"-shaped Cutout
in Chassis
Chassis
One Piece Log Set
Burner
Ports