Valor Auto Companion Inc. 1210DKA Indoor Fireplace User Manual


 
2
© Copyright Miles Industries Ltd., 2007.
3/8”
3/4”
Installation
Install heater as per installation instructions.
Finish wall up to the outside edge of the rebox
front opening. Allow for height of nished hearth
or backing plate will not install. Make sure that
the wall nish is no thicker than 1/2”.
Remove the 6 screws retaining the top and
side black strips surrounding the opening of the
rebox, as shown.
Install the backing plate with the four screws
provided, xing it at the top and on each side,
as shown.
In the middle of the replace’s black sheet metal
front plinth, drill through the two dimples with an
1/8” bit.
Fix the magnet bracket to the black sheet metal
front plinth with the two screws provided.
1.
2.
3.
4.
5.
Insert one hinge pin, long side up, in one of the bottom
hinge brackets on the backing plate.
Drop the bottom of one door onto the hinge pin.
Align the top of the door under the upper hinge bracket.
Drop the top hinge pin through the bracket, in the door
frame. Repeat with the other door.
6.
7.
8.