Filter
Top Products
The floodlight remains on the set time between
5 seconds and 18 minutes (approximate).
The manual mode permits you to turn the
security floodlight on for as long a time period
as you desire. You end the on-time by manually
turning the security floodlight off and then back
on after 5 seconds (the security floodlight is
now in the automatic mode). In the manual
mode, the light sensor, infrared sensor and the
timer are disabled.
If the wall switch is set to off continuously, the
security floodlight does not operate at any time.
Automatic Operation
To place the security floodlight in the automatic
mode, turn the wall switch off, then turn it back
on after 5 seconds or longer. The security
floodlight will come on for the time duration set
and then turn off. You may now leave the wall
switch on continuously. The security floodlight
will only come on in darkness when it detects
something in the pattern and will go off at the
end of the time period.
Manual Operation
To place the security floodlight in the manual
mode so that the security floodlight will remain
on continuously (for example, if you're having
an outdoor party), turn the wall switch off and
then on again immediately (in less than 2
seconds). If the wall switch had been off, turn
the switch on for 5 seconds or longer and then
turn off and immediately on again.
OPERATION WHERE A WALL
SWITCH IS NOT INSTALLED
If a wall switch is not installed, your security
floodlight operates in the automatic mode only.
The system is always controlled by the solid-
state circuits in the sensor. The security
floodlight will only come on in darkness when
it detects something in the pattern and it will
shut off at the end of the time period.
NOTE
By using the existing circuit
breaker, the security light can
be operated in a "manual"
mode much the same as in
the manual mode when a wall
switch is installed.
Set the circuit breaker
controlling power to the
security floodlight to off and
then immediately on (in less
than 2 seconds); the
floodlights will remain on. To
reset the security floodlight
to automatic operation again,
set the circuit breaker off and
set the breaker to on again
after 5 seconds or longer. The
floodlights will come on for
the set time duration then go
off and remain in the
automatic mode.
FINAL ADJUSTMENTS
Once the security floodlight has operated for
several days, you may want to make several
final adjustments: sensitivity, duration of on-
time and activation prior to complete darkness.
Make these adjustments as follows:
Sensitivity (SENS/RANGE)
If family pets or other interference cause the
security floodlight to come on, make the
floodlight less sensitive. Turn the SENS/
RANGE control counterclockwise to make the
floodlight less sensitive (or clockwise to make
it more sensitive).
Duration of On-Time
The on-time of the security floodlight is variable
from 5 seconds to about 18 minutes. Turn the
TIME control clockwise to increase the on-time.
Turn the TIME control counterclockwise to
decrease the on -time.
Activation Prior to Complete
Darkness
If you want the security floodlight to activate at
dusk instead of complete darkness, turn the
DAYLIGHT/TEST-ON control a small distance
counterclockwise.