Filter
Top Products
14 USSC
SHUT DOWN PROCEDURE
Press the “OFF” button on the control panel to put the furnace in shut down mode. At this time, the red light above the
“OFF” button will illuminate. Once this is done, the auger will stop feeding fuel, but the room air fan(s) and draft fan will
continue to operate. When the internal temperature of the unit drops below the factory preset temperatures, the room
air fans and draft fan will cease to operate. The red light will then shut off and the unit will be completely shut down.
The hotter the unit is during its operation, the longer it will take for the furnace to complete the shut down cycle. If the
furnace stays on for more than 2 hours after pressing the “OFF” button and you are sure that the fire is out, the furnace
can be unplugged from the outlet. After approximately 10 seconds, the unit can be re-connected to the power source
and the control board will be reset.
Operation
START-UP PROCEDURE
Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or
“freshen up” a fire in this furnace. Keep all such liquids well away from the furnace while it is in use.
Verify that the hopper is clean and free of foreign matter.
Verify that all of the required exhaust/inlet connections have been made in accordance with this manual and that the
furnace is plugged into an outlet (an outlet surge protector is highly recommended).
Fill the hopper with fuel; do not allow any part of the bag or any other foreign material into the hopper, as this may jam
the auger. Ensure that all fuel matter is cleared from the hopper seating surface. Close the hopper lid.
Make sure that the furnace is in the “OFF” mode, then place wood pellets or fire starter pellets (Pellets that already
contain fire starter.) in the burnpot up to agitator shaft level. Squirt a small amount of fire starter gel on the pellets.
(Not needed if using fire starter pellets.) Light the fire then wait approx. 1 minute for the fire to start burning the
pellets.
NOTE: Even if you are burning corn, wood pellets make an excellant source of starter fuel.
Close the viewing door then press the “ON” button on the control pad and set the “HEAT SETTING” to Hr-3. This
allows the furnace to come up to operating temperature..
The damper located on the front of the unit can be adjusted for optimum performance. Whether using wood pellets
or corn, small adjustments to the damper can make a big difference. When adjusted properly, there should be very
minimal amount of ash in the burn chamber. This also depends on the quality of the fuel used. When burning corn
in the model 6100, set the damper to the mid postion. (approx. 12 o’clock position) For the model 6110, pull the
damper out between 1 inch and 1½ inches
Fuel will start feeding after three(3) minutes
As an alternate method of startup, the furnace may be put into “Manual” mode as described under the “Control
Panel” section in this manual.
1.)
2.)
3.)
4.)
5.)
6.)
7.)
ÌÌ
ÌÌ
Ì
First Fire: Adjust the “HEAT RANGE” and “ROOM FAN” to a medium setting and allow the furnace
to operate in this manner for approximately three (3) hours (or more if necessary), allowing the furnace to
“cure out” as the paint and oils from the manufacturing process burn off. We recommend that you open
doors and windows in your home during this process.
WARNING: Never shut down this unit by unplugging it from the power source.
1.)
2.)
UNIT PREPARATION
After carefully unpacking and reading the instructions for installing your furnace, you will need to perform the following
steps:
Attach the included spring handle to the door handle by screwing it on in a respective location.
Attach the electrical cord to the back of the furnace first; then plug it into a 110-volt outlet (an outlet surge protector
is highly recommended).