Filter
Top Products
20
5
SAFETY NOTICE
In the unlikely event that your 2931 "overfires" (a condition evidenced by elbows,
stovepipes, and connectors glowing red in appearance or otherwise discoloring),
then your installation is subject to excessive draft created by either a chimney too tall
or too great in diameter in conjunction with its height, or some other factor of an
indeterminate cause. In this event, you should install a barometric draft regulator.
Such installation will preclude any overfiring and/or any hazardous consequences
of potential overfiring.
Barometric draft regulators are generally available where you purchased your stove
or may be ordered directly from United States Stove Company at a nominal charge.
BAROMETRIC DRAFT REGULATOR
Model DR6
1996 Consumer Price:
$22.00 - Includes Shipping and Handling
1/4-20 Kep Nut
Flue Collar Gasket
Flue Collar
1/4-20x3/4" Bolt
INSTALLING FLUE COLLAR
This heater has been shipped with the flue collar unattached for shipping purposes.
To install the flue collar simply follow the instructions below.
The following parts are necessary to install the flue collar:
1 - Flue collar
1 - Flue collar gasket
6 - 1/4-20x3/4" bolts
6 - 1/4-20 Kep nuts
1. Slide the flue collar gasket over the flue collar.
2. Place flue collar into the heaters firebox and thru the hole
in the back upper left hand corner.
3. Align the holes in the flue collar with those in the firebox.
4. Insert the (6) 1/4-20x3/4" Bolts thru the flue collar and
attach
the (6) 1/4-20 Kep nuts.
5. Tighten each Kep nut to ensure a good seal between the
flue collar and the firebox back.
NOTE: The below drawing is an illustration to assist in the
installation of the flue collar. The Feed door and Ash door
have been left off for viewing purposes only.