Filter
Top Products
Assembly Instructions
SRFANWM
Wall-Mount Enclosure Cooling Solution
Alternative Installation
Fans mounted outside the Wall-Mount cabinet draw air out of the cabinet for proper equipment cooling.
1
For external installation, begin by
installing the fan into the shroud using
the supplied hardware.
4
Plug the SRFANWM input cable into
a power source, such as an external
source. For connection to an internal
PDU, utilize the removable cable access
panel.
2
Mount the assembly over the vents on
the exterior of the Wall-Mount cabinet,
threading the screws from the inside of
the cabinet.
3
Secure the wire between each fan to
the cabinet using the peel-and-stick
cable anchor with tie.
1
4
2 3
201105092 93-3111
1111 W. 35th Street • Chicago, IL 60609 USA
www.tripplite.com/support
© 2011 Tripp Lite. All rights reserved.
SAVE THESE
INSTRUCTIONS
This manual contains instructions and warnings that must be followed during the installation and
operation of the product described in this manual. Read all instructions and warnings thoroughly
before attempting installation. Failure to comply may affect the warranty and cause property damage
and personal injury.
• Install in a controlled indoor environment, away from moisture, temperature extremes, ammable
liquids and gasses, conductive contaminants, dust and direct sunlight.
• Inspect the shipping container and the unit for shipping damage. Do not use the unit if it is damaged.
• Connect the unit to an outlet that is provided with appropriate overcurrent protection.
• When using tools, use eye protection and follow all other safety precautions recommended by the
tool manufacturer and required by applicable regulations.
• Keep hair, clothing and loose objects away from the fan intakes. There is a risk of property
damage and personal injury.
• Do not block, cover or insert objects into the openings of the unit.
• Use of this equipment in life support applications where failure of this equipment can reasonably
be expected to cause failure of the life support equipment or to significantly affect its safety or
effectiveness is not recommended. Do not use this equipment in the presence of a flammable
anesthetic mixture with air, oxygen or nitrous oxide.