Trane FTXS24DVJU Air Conditioner User Manual


 
8 English
Preparation Before Operation
To operate the remote controller
To use the remote controller, aim the transmitter at the indoor unit.
If there is anything to block signals between the unit and the
remote controller, such as a curtain, the unit will not operate.
Do not drop the remote controller. Do not get it wet.
The maximum distance for communication is about 23 Ft..
To fix the remote controller holder on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the holder to a wall, a pillar, or similar location with
the screws procured locally.
3. Place the remote controller in the remote controller
holder.
ATTENTION
About remote controller
Do not put the remote controller in the following places.
In direct sunlight.
In vicinity of a heater.
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such
as inverter-type lamps) is in the room. Consult your authorized dealer if that is the case.
If the remote controller signals happen to operate another appliance, move that appliance to
somewhere else, or consult your authorized dealer.
Receiver
Remote controller
holder
Set.
To remove, pull it upwards.
01_EN_3P141693-2C (A4).fm Page 8 Saturday, September 25, 2004 11:39 AM